search
Contact Uscybus.io

Upgrading Connectware (Docker)

Upgrade Connectware on Docker.

circle-exclamation

When upgrading your Connectware instance, follow the upgrade path based on your current version.

For all version upgrades that are not listed below, you can simply follow the regular Connectware upgrade guide.

  • If you are on version 1.4.1 or below

    • Upgrade sequentially: 1.5.0 → 1.7.0 → 2.0.0 → 2.0.1 → 2.0.2 → 2.0.5

  • If you are between version 1.5.0 and 1.6.2

    • Upgrade sequentially: 1.7.0 → 2.0.0 → 2.0.1 → 2.0.2 → 2.0.5

  • If you are on version 1.7.0 or newer (but below 2.0.0)

    • Upgrade sequentially: 2.0.0 → 2.0.1 → 2.0.2 → 2.0.5

  • If you are on version 2.0.0

    • Upgrade sequentially: 2.0.1 → 2.0.2 → 2.0.5

  • If you are on version 2.0.1

    • Upgrade sequentially: 2.0.2 → 2.0.5

  • If you are on version 2.0.2, 2.0.3, or 2.0.4

    • Upgrade directly to 2.0.5

  • If you are performing a clean or new installation

    • No upgrade path required. You can install the latest available version directly.

Detailed instructions on each upgrade step

circle-exclamation

Downgrading to previous Connectware versions is not supported.

hashtag
Upgrading Connectware to a New Version

  • To upgrade Connectware to a newer version, get the latest installer script by following the steps in the Prepare Installer Script chapter. When running the update, select your current Connectware installation directory.

The update will automatically preserve your existing configuration, including your license key and network settings. If you're prompted to enter a license key during the update, this usually means you have selected the wrong installation directory. In this case, cancel the update and verify you have chosen the correct path.

circle-exclamation

If you originally installed Connectware using sudo privileges, make sure to use sudo when running the update as well.

hashtag
Upgrading Connectware in Silent Mode

The installer supports an automated deployment mode that requires no manual intervention. You can activate this by using either -s or --silent, and -d(directory) when running the installation script.

If you need to customize your installation, the script offers several configuration options. Run the installer with --help to view all available parameters.

Example

PreviousUpgrading Connectware from 1.x to 1.5.0 (Kubernetes)NextUpgrading Connectware to 2.1.0 (Docker)

Last updated

Was this helpful?